Kategorije

Elektricni klaviri i oprema
Kablovi,konektori i adapteri

Brendovi

Audio-Technica PRO70

Condenser Cardioid Instrument Microphone

160.00

This miniature condenser microphone achieves full-sounding pickup and is known for outstanding consistency and dependable performance. Supplied with both a clothing clip and guitar mount, it provides natural and articulate vocal reproduction when used as a clip-on lavalier and excels in pickup of acoustic guitar. The PRO70 is designed to make music and speech clearly and comfortably audible, yet never draw attention to itself or its operation. The microphone is equipped with a low-frequency roll-off switch that allows for reduced pickup of room noise. The versatile PRO70 may be powered by either battery or phantom power. Its cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source.

Miniature condenser microphone is ideal for both vocal and acoustic guitar applications

Natural and articulate vocal reproduction when used as a clip-on lavalier – clothing clip included

Excels in pickup of acoustic guitar with included instrument adapter

Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source

Switchable low-frequency roll-off

Corrosion-resistant contacts from gold-plated XLRM-type connector

Operates on battery or phantom power

6′ (1.8 m) cable permanently attached between microphone and power module

Element

Fixed-charge back plate, permanently polarized condenser

Polar Pattern

Cardioid

Frequency Response

100 – 14,000 Hz

Open Circuit Sensitivity

Phantom: -45 dB (5.6 mV) re 1V at 1 Pa Battery: -45 dB (5.6 mV) re 1V at 1 Pa

Impedance

Phantom: 200 ohms Battery: 200 ohms

Maximum Input Sound Level

Phantom: 123 dB SPL, 1 kHz at 1% T.H.D. Battery: 123 dB SPL, 1 kHz at 1% T.H.D.

Low Frequency Roll Off

80 Hz, 18 dB/octave

Switches

Off, on-flat, on-roll-off

Dynamic Range

Phantom: 96 dB, 1 kHz at Max SPL Battery: 96 dB, 1 kHz at Max SPL

Signal-to-Noise Ratio

67 dB, 1 kHz at 1 Pa

Phantom Power Requirements

11-52V DC, 2 mA typical

Battery Type

1.5V AA/UM3

Battery Current/Life

0.4 mA / 1200 hours typical (alkaline)

Weight

8 g / 134 g (Power module)

Dimensions

21mm (long) ; Ø body 10.2mm

Output Connector

Integral 3-pin XLRM-type

Cable

Integral 6′ (1.8 m), permanently attached between microphone and power module

Accessories Included

AT8411 clothing clip; AT8444 instrument adapter; power module; windscreen; battery; soft protective pouch